Once the glue does begin to soften, attempt to wedge a small edge or spatula between the loosening spot and the wood. With any luck, the glue will lift off, leaving behind a small amount of residue. If the wood surface is unpainted, try oils to help lift the glue and help wipe away residue. 2.
6. Color in scratches with a wood stain. Minimize the appearance of deep scratches with a wood stain, which comes in oil-based, water-based, gel, and combination varieties.Oil-based stains dry
You can reduce the gloss of an existing finish by gently wet sanding with 600 or 800 grit sandpaper. The higher the grit, the glossier the finish will be. In general, buffing will also increase glossiness. An alternative solution would be adding a coat of compatible satin or matte poly or varnish on top of the existing finish.
Using a bowl with water and dish soap, scrub the item with a soft brush. Be sure to use a soft brush if it’s an item that you’re nervous about possibly scratching. Spray the item with a hose until the water runs clear. If it isn’t fully rinsed, it will leave a white residue on the furniture.

Getting nail polish off a wood table is simpler than you might think. Act quickly to remove the spill before it dries. Use a plastic card to scoop up excess polish. Blot the stain gently with non-acetone nail polish remover. Rehydrate the wood with a DIY conditioner post-cleaning. For tough stains, try rubbing alcohol or hairspray.

Let the turpentine bubble. This means that the thinner is already reacting with the tung oil finish. Depending on how hard the tung oil coating is, it may take some time to bubble up. Step 2. Scrape with fine steel wool. Once the test spot is bubbling with turpentine, the next step is to sand it with fine steel wool.
WZyKu57. 312 49 79 311 278 424 206 46 9

how to remove finish from wood